Diy repairing a hole or crack in an aluminum boat super easy repairing damaged/cracked aluminum jon boat hulls. aluminum boat hull repair for aluminum jon boats #tbnation - duration:. Hello - i have a 17 foot aluminum boat and i recently noticed a crack that is seeping water. i had it on the water over the weekend and had to bilge it a few times, so when i got home, i filled it up with water and found a crack in the passenger side of the hull, more towards the front of the boat.. I have to fix a small crack in a lapstrake aluminum hull, it's a small split about 3/8" long right at the corner or upper end of a rib. i welded a section on my jon boat with good results, but that was along an existing weld. i have an air powered riveter for aluminum, it's made for airframe repair that does a really nice job on.
I just picked up a 12 ft jon boat. i noticed that it has a couple of cracks in it. about an inch long. i didnt know if anone had a recoomendation on how to fit these. the aluminum isnt very thick, i was thinking jb weld then coating the bottom with flex seal.. This makes aluminum boats easier to repair than other designs. unfortunately, all boats suffer impact damage, collision or hard-grounding that can lead to leaks and cracked seams. fortunately, special brazen rods have been designed specifically to patch and fill in holes on damaged aluminum boats, allowing boat owners to perform self repairs.. Repairs leaks in aluminum boats. this fusion bondage epoxy will repair and waterproof aluminum boat rivets, minor cracks and small holes without welding. easy to apply; no solvents or mixing. all you need is a standard torch and fine sandpaper or a wire brush. instructions included. large size.
Comments
Post a Comment